blob: 2886bcb7527cd6f4c83cc16540cbf803451e247a (
plain) (
blame)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
|
#!nsh
echo "[init] 09_ardrone_flow: PX4FMU on PX4IOAR carrier board with PX4FLOW"
#
# Load default params for this platform
#
if param compare SYS_AUTOCONFIG 1
then
# Set all params here, then disable autoconfig
param set MC_ATTRATE_D 0
param set MC_ATTRATE_I 0
param set MC_ATTRATE_P 0.13
param set MC_ATT_D 0
param set MC_ATT_I 0.3
param set MC_ATT_P 5
param set MC_YAWPOS_D 0.1
param set MC_YAWPOS_I 0.15
param set MC_YAWPOS_P 1
param set MC_YAWRATE_D 0
param set MC_YAWRATE_I 0
param set MC_YAWRATE_P 0.15
param set SYS_AUTOCONFIG 0
param save
fi
#
# Force some key parameters to sane values
# MAV_TYPE 2 = quadrotor
#
param set MAV_TYPE 2
param set BAT_V_SCALING 0.008381
#
# Start MAVLink and MAVLink Onboard (PX4FLOW Sensor)
#
mavlink start -d /dev/ttyS0 -b 57600
mavlink_onboard start -d /dev/ttyS3 -b 115200
usleep 5000
#
# Configure PX4FMU for operation with PX4IOAR
#
fmu mode_gpio_serial
#
# Fire up the AR.Drone interface.
#
ardrone_interface start -d /dev/ttyS1
#
# Start the sensors.
#
sh /etc/init.d/rc.sensors
#
# Start the attitude estimator
#
attitude_estimator_ekf start
#
# Start the position estimator
#
flow_position_estimator start
#
# Fire up the multi rotor attitude controller
#
multirotor_att_control start
#
# Fire up the flow position controller
#
flow_position_control start
#
# Fire up the flow speed controller
#
flow_speed_control start
# Exit, because /dev/ttyS0 is needed for MAVLink
exit
|
