README.txt ^^^^^^^^^^ ZDS-II Compiler Versions ^^^^^^^^^^^^^^^^^^^^^^^^ 4.11.0 This is the only version that this code has been built against. Although it compiles without error, the 4.11.0 compiler generates bad code on one of the files, mm/mm_initialize.c. Below is a simple work- around. --- mm/mm_initialize.c.SAVE 2008-02-13 08:06:46.833857700 -0600 +++ mm/mm_initialize.c 2008-02-13 08:07:26.367608900 -0600 @@ -94,8 +94,11 @@ { int i; +#if 0 /* DO NOT CHECK IN */ CHECK_ALLOCNODE_SIZE; CHECK_FREENODE_SIZE; +#endif /* Set up global variables */ Other Versions If you use any version of ZDS-II other than 4.11.0 or if you install ZDS-II at any location other than the default location, you will have to modify two files: (1) configs/ez80f910200kitg/*/setenv.sh and (2) configs/ez80f910200kitg/*/Make.defs. Configuration Subdirectories ^^^^^^^^^^^^^^^^^^^^^^^^^^^^ - src/ and include/ These directories contain common logic for all ez80f910200kitg configurations. Variations on the basic ez80f910200kitg configuration are maintained in subdirectories. To configure any specific configuration, do the following steps: cd /tools ./configure.sh ez80f910200kitg/ cd make Where is the specific board configuration that you wish to build. The following board-specific configurations are available: - ostest This builds the examples/ostest application for execution from FLASH. See examples/README.txt for information about ostest. Check out any README.txt files in these s.