diff options
-rw-r--r-- | nuttx/configs/sama5d4-ek/README.txt | 10 | ||||
-rw-r--r-- | nuttx/configs/stm3240g-eval/README.txt | 4 |
2 files changed, 7 insertions, 7 deletions
diff --git a/nuttx/configs/sama5d4-ek/README.txt b/nuttx/configs/sama5d4-ek/README.txt index 406b1dbdc..771c3b6da 100644 --- a/nuttx/configs/sama5d4-ek/README.txt +++ b/nuttx/configs/sama5d4-ek/README.txt @@ -4831,8 +4831,8 @@ To-Do List a) With a logic analyzer I can see that the I2C writes to the WM8904 device look good. This is the same setup that was used in the working - SAMA5D3x-EK nxplayer configuration and so should be correct (you cannot - even get this far on the Rev C board). + SAMA5D3x-EK nxplayer configuration and so should be correct (you + cannot even get this far on the Rev C board). b) I2C readback of the WM8904 registers (via CONFIG_WM8904_REGDUMP) does not, however, show proper registers contents. Groups of extra bits (apparently 0x01fd) appear to be set in many registers on reading. @@ -4842,9 +4842,9 @@ To-Do List before anything has been written to it. c) Also with the logic analyzer, I can that the 12MHz MCLK input is being provided to the WM8904. - d) However, not bit clock (BLCK) is being generated by the WM8904. This - should appear on both AUDIO_TK0_PB27 and AUDIO_RK0_PB28, but I see - nothing. + d) However, no bit clock (BLCK) is being generated by the WM8904. This + should appear on both AUDIO_TK0_PB27 and AUDIO_RK0_PB28, but I do not + see a clock on these pins. e) With no BCLK, I would expect the SSC0 DMA transfers to hang... they do not. No errors of any kind are detected by the firmware; it believes that it is successfully playing .WAV files. This leads to believe diff --git a/nuttx/configs/stm3240g-eval/README.txt b/nuttx/configs/stm3240g-eval/README.txt index 5b9c8749d..f3be1fa4f 100644 --- a/nuttx/configs/stm3240g-eval/README.txt +++ b/nuttx/configs/stm3240g-eval/README.txt @@ -995,11 +995,11 @@ Where <subdir> is one of the following: CONFIG_ARMV7M_TOOLCHAIN_CODESOURCERYW=y : CodeSourcery under Windows CONFIG_CXX_NEWLONG=n : size_t is unsigned int (maybe?) - 3. In addition to the the kernel mode build, this NxWM configuration + 3. In addition to the protected mode build, this NxWM configuration differences from the nxwm configuration in that: a. Networking is disabled. There are issues with some of the network- - related NSH commands and with Telnet in the kernel build (see the + related NSH commands and with Telnet in the protected build (see the top-level TODO file). Without these NSH commands, there is no use for networking in this configuration. |