blob: 25ea25ae88adf09ff89f94d3b72d9e9c15930500 (
plain) (
tree)
|
|
#!nsh
#
# USB HIL start
#
echo "[HIL] HILS quadrotor starting.."
#
# Load default params for this platform
#
if param compare SYS_AUTOCONFIG 1
then
# Set all params here, then disable autoconfig
param set SYS_AUTOCONFIG 0
param set MC_ATTRATE_D 0.0
param set MC_ATTRATE_I 0.0
param set MC_ATTRATE_P 0.05
param set MC_ATT_D 0.0
param set MC_ATT_I 0.0
param set MC_ATT_P 3.0
param set MC_YAWPOS_D 0.0
param set MC_YAWPOS_I 0.0
param set MC_YAWPOS_P 2.1
param set MC_YAWRATE_D 0.0
param set MC_YAWRATE_I 0.0
param set MC_YAWRATE_P 0.05
param set NAV_TAKEOFF_ALT 3.0
param set MPC_TILT_MAX 0.5
param set MPC_THR_MAX 0.5
param set MPC_THR_MIN 0.1
param set MPC_XY_D 0
param set MPC_XY_P 0.5
param set MPC_XY_VEL_D 0
param set MPC_XY_VEL_I 0
param set MPC_XY_VEL_MAX 3
param set MPC_XY_VEL_P 0.2
param set MPC_Z_D 0
param set MPC_Z_P 1
param set MPC_Z_VEL_D 0
param set MPC_Z_VEL_I 0.1
param set MPC_Z_VEL_MAX 2
param set MPC_Z_VEL_P 0.20
param save
fi
# Allow USB some time to come up
sleep 1
# Tell MAVLink that this link is "fast"
mavlink start -b 230400 -d /dev/ttyACM0
# Create a fake HIL /dev/pwm_output interface
hil mode_pwm
#
# Force some key parameters to sane values
# MAV_TYPE 1 = fixed wing, 2 = quadrotor, 13 = hexarotor
# see https://pixhawk.ethz.ch/mavlink/
#
param set MAV_TYPE 2
#
# Check if we got an IO
#
if px4io start
then
echo "IO started"
else
if hw_ver compare PX4FMU_V1
then
fmu mode_serial
echo "FMU started"
fi
fi
#
# Start the sensors (depends on orb, px4io)
#
sh /etc/init.d/rc.sensors
#
# Start the attitude estimator (depends on orb)
#
att_pos_estimator_ekf start
#
# Load mixer and start controllers (depends on px4io)
#
mixer load /dev/pwm_output /etc/mixers/FMU_quad_x.mix
#
# Start position estimator
#
position_estimator_inav start
#
# Start attitude control
#
multirotor_att_control start
#
# Start position control
#
multirotor_pos_control start
echo "[HIL] setup done, running"
|