diff options
Diffstat (limited to 'ROMFS/px4fmu_common/init.d/08_ardrone')
| -rw-r--r-- | ROMFS/px4fmu_common/init.d/08_ardrone | 86 |
1 files changed, 16 insertions, 70 deletions
diff --git a/ROMFS/px4fmu_common/init.d/08_ardrone b/ROMFS/px4fmu_common/init.d/08_ardrone index f55ac2ae3..eb9f82f77 100644 --- a/ROMFS/px4fmu_common/init.d/08_ardrone +++ b/ROMFS/px4fmu_common/init.d/08_ardrone @@ -1,99 +1,45 @@ #!nsh -# -# Flight startup script for PX4FMU on PX4IOAR carrier board. -# - -# Disable the USB interface -set USB no -# Disable autostarting other apps -set MODE ardrone - -echo "[init] doing PX4IOAR startup..." - -# -# Start the ORB -# -uorb start +echo "[init] 08_ardrone: PX4FMU on PX4IOAR carrier board" # -# Load microSD params +# Load default params for this platform # -echo "[init] loading microSD params" -param select /fs/microsd/params -if [ -f /fs/microsd/params ] +if param compare SYS_AUTOCONFIG 1 then - param load /fs/microsd/params + # Set all params here, then disable autoconfig + # TODO + + param set SYS_AUTOCONFIG 0 + param save /fs/microsd/params fi # # Force some key parameters to sane values -# MAV_TYPE 1 = fixed wing, 2 = quadrotor, 13 = hexarotor -# see https://pixhawk.ethz.ch/mavlink/ +# MAV_TYPE 2 = quadrotor # param set MAV_TYPE 2 # -# Configure PX4FMU for operation with PX4IOAR -# -fmu mode_gpio_serial - -# -# Start the sensors. -# -sh /etc/init.d/rc.sensors - -# # Start MAVLink # mavlink start -d /dev/ttyS0 -b 57600 usleep 5000 - -# -# Start the commander. -# -commander start - -# -# Start the attitude estimator -# -attitude_estimator_ekf start - + # -# Fire up the multi rotor attitude controller +# Configure PX4FMU for operation with PX4IOAR # -multirotor_att_control start +fmu mode_gpio_serial # # Fire up the AR.Drone interface. # ardrone_interface start -d /dev/ttyS1 - -# -# Start logging -# -sdlog start -s 10 - -# -# Start GPS capture -# -gps start - -# -# Start system state -# -if blinkm start -then - echo "using BlinkM for state indication" - blinkm systemstate -else - echo "no BlinkM found, OK." -fi # -# startup is done; we don't want the shell because we -# use the same UART for telemetry +# Start common for all multirotors apps # -echo "[init] startup done" - +sh /etc/init.d/rc.multirotor + +# Exit, because /dev/ttyS0 is needed for MAVLink exit |