1 files changed, 0 insertions, 95 deletions
diff --git a/nuttx/drivers/net/Kconfig b/nuttx/drivers/net/Kconfig
deleted file mode 100644
index d8878ecaf..000000000
--- a/nuttx/drivers/net/Kconfig
+++ /dev/null
@@ -1,95 +0,0 @@
-#
-# For a description of the syntax of this configuration file,
-# see misc/tools/kconfig-language.txt.
-#
-config NET_DM90x0
-	bool "Davicom dm9000/dm9010 support"
-	default n
-	---help---
-		References: Davicom data sheets (DM9000-DS-F03-041906.pdf,
-		DM9010-DS-F01-103006.pdf) and looking at lots of other DM90x0
-		drivers.
-
-config NET_CS89x0
-	bool "CS89x0 support"
-	default n
-	depends on EXPERIMENTAL
-	---help---
-	Under construction -- do not use
-	
-config ENC28J60
-	bool "Microchip ENC28J60 support"
-	default n
-	select SPI
-	---help---
-		References:
-		ENC28J60 Data Sheet, Stand-Alone Ethernet Controller with SPI Interface,
-		DS39662C, 2008 Microchip Technology Inc.
-
-if ENC28J60
-config ENC28J60_NINTERFACES
-	int "Number of physical ENC28J60"
-	default 1
-	range 1,1
-	---help---
-		Specifies the number of physical ENC28J60
-		devices that will be supported.
-
-config ENC28J60_SPIMODE
-	int "SPI mode"
-	default 0
-	---help---
-		Controls the SPI mode.  The ENC28J60 spec says that it supports SPI
-		mode 0,0 only: "The implementation used on this device supports SPI
-		mode 0,0 only. In addition, the SPI port requires that SCK be at Idle
-		in a low state; selectable clock polarity is not supported."
-		However, sometimes you need to tinker with these things.
-
-config ENC28J60_FREQUENCY
-	int "SPI frequency"
-	default 20000000
-	---help---
-		Define to use a different bus frequency
-
-config ENC28J60_STATS
-	bool "Network statistics support"
-	default n
-	---help---
-		Collect network statistics
-
-config ENC28J60_HALFDUPPLEX
-	bool "Enable half dupplex"
-	default n
-	---help---
-		Default is full duplex
-
-config ENC28J60_DUMPPACKET
-	bool "Dump Packets"
-	default n
-	---help---
-		If selected, the ENC28J60 driver  will dump the contents of each
-		packet to the console.
-
-config ENC28J60_REGDEBUG
-	bool "Register-Level Debug"
-	default n
-	depends on DEBUG && DEBUG_NET
-	---help---
-		Enable very low-level register access debug.  Depends on DEBUG and DEBUG_NET.
-
-endif
-
-config NET_E1000
-	bool "E1000 support"
-	default n
-
-config NET_SLIP
-	bool "SLIP (serial line) support"
-	default n
-	---help---	
-		Reference: RFC 1055
-
-config NET_VNET
-	bool "VNET support"
-	default n
-