diff options
Diffstat (limited to 'nuttx/drivers/net/Kconfig')
-rw-r--r-- | nuttx/drivers/net/Kconfig | 95 |
1 files changed, 0 insertions, 95 deletions
diff --git a/nuttx/drivers/net/Kconfig b/nuttx/drivers/net/Kconfig deleted file mode 100644 index d8878ecaf..000000000 --- a/nuttx/drivers/net/Kconfig +++ /dev/null @@ -1,95 +0,0 @@ -# -# For a description of the syntax of this configuration file, -# see misc/tools/kconfig-language.txt. -# -config NET_DM90x0 - bool "Davicom dm9000/dm9010 support" - default n - ---help--- - References: Davicom data sheets (DM9000-DS-F03-041906.pdf, - DM9010-DS-F01-103006.pdf) and looking at lots of other DM90x0 - drivers. - -config NET_CS89x0 - bool "CS89x0 support" - default n - depends on EXPERIMENTAL - ---help--- - Under construction -- do not use - -config ENC28J60 - bool "Microchip ENC28J60 support" - default n - select SPI - ---help--- - References: - ENC28J60 Data Sheet, Stand-Alone Ethernet Controller with SPI Interface, - DS39662C, 2008 Microchip Technology Inc. - -if ENC28J60 -config ENC28J60_NINTERFACES - int "Number of physical ENC28J60" - default 1 - range 1,1 - ---help--- - Specifies the number of physical ENC28J60 - devices that will be supported. - -config ENC28J60_SPIMODE - int "SPI mode" - default 0 - ---help--- - Controls the SPI mode. The ENC28J60 spec says that it supports SPI - mode 0,0 only: "The implementation used on this device supports SPI - mode 0,0 only. In addition, the SPI port requires that SCK be at Idle - in a low state; selectable clock polarity is not supported." - However, sometimes you need to tinker with these things. - -config ENC28J60_FREQUENCY - int "SPI frequency" - default 20000000 - ---help--- - Define to use a different bus frequency - -config ENC28J60_STATS - bool "Network statistics support" - default n - ---help--- - Collect network statistics - -config ENC28J60_HALFDUPPLEX - bool "Enable half dupplex" - default n - ---help--- - Default is full duplex - -config ENC28J60_DUMPPACKET - bool "Dump Packets" - default n - ---help--- - If selected, the ENC28J60 driver will dump the contents of each - packet to the console. - -config ENC28J60_REGDEBUG - bool "Register-Level Debug" - default n - depends on DEBUG && DEBUG_NET - ---help--- - Enable very low-level register access debug. Depends on DEBUG and DEBUG_NET. - -endif - -config NET_E1000 - bool "E1000 support" - default n - -config NET_SLIP - bool "SLIP (serial line) support" - default n - ---help--- - Reference: RFC 1055 - -config NET_VNET - bool "VNET support" - default n - |