blob: 8fe94452f8aa90ac862771e8c38652cb77093ab9 (
plain) (
blame)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
|
#!nsh
echo "[init] PX4FMU v1, v2 with or without IO on Phantom FPV"
#
# Load default params for this platform
#
if param compare SYS_AUTOCONFIG 1
then
# Set all params here, then disable autoconfig
param set FW_P_D 0
param set FW_P_I 0
param set FW_P_IMAX 15
param set FW_P_LIM_MAX 50
param set FW_P_LIM_MIN -50
param set FW_P_P 60
param set FW_P_RMAX_NEG 0
param set FW_P_RMAX_POS 0
param set FW_P_ROLLFF 1.1
param set FW_R_D 0
param set FW_R_I 5
param set FW_R_IMAX 20
param set FW_R_P 100
param set FW_R_RMAX 100
param set FW_THR_CRUISE 0.65
param set FW_THR_MAX 1
param set FW_THR_MIN 0
param set FW_T_SINK_MAX 5.0
param set FW_T_SINK_MIN 4.0
param set FW_Y_ROLLFF 1.1
param set FW_L1_PERIOD 17
param set SYS_AUTOCONFIG 0
param save
fi
#
# Force some key parameters to sane values
# MAV_TYPE 1 = fixed wing
#
param set MAV_TYPE 1
set EXIT_ON_END no
#
# Start and configure PX4IO or FMU interface
#
if px4io detect
then
# Start MAVLink (depends on orb)
mavlink start
commander start
sh /etc/init.d/rc.io
# Limit to 100 Hz updates and (implicit) 50 Hz PWM
px4io limit 100
else
# Start MAVLink (on UART1 / ttyS0)
mavlink start -d /dev/ttyS0
commander start
fmu mode_pwm
param set BAT_V_SCALING 0.004593
set EXIT_ON_END yes
fi
#
# Start the sensors and test them.
#
sh /etc/init.d/rc.sensors
#
# Start logging (depends on sensors)
#
sh /etc/init.d/rc.logging
#
# Start GPS interface (depends on orb)
#
gps start
#
# Start the attitude and position estimator
#
att_pos_estimator_ekf start
#
# Load mixer and start controllers (depends on px4io)
#
mixer load /dev/pwm_output /etc/mixers/FMU_Q.mix
fw_att_control start
fw_pos_control_l1 start
if [ $EXIT_ON_END == yes ]
then
exit
fi
|