blob: d8878ecafd47cadcdd98e9516b689cab1a977cc4 (
plain) (
blame)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
|
#
# For a description of the syntax of this configuration file,
# see misc/tools/kconfig-language.txt.
#
config NET_DM90x0
bool "Davicom dm9000/dm9010 support"
default n
---help---
References: Davicom data sheets (DM9000-DS-F03-041906.pdf,
DM9010-DS-F01-103006.pdf) and looking at lots of other DM90x0
drivers.
config NET_CS89x0
bool "CS89x0 support"
default n
depends on EXPERIMENTAL
---help---
Under construction -- do not use
config ENC28J60
bool "Microchip ENC28J60 support"
default n
select SPI
---help---
References:
ENC28J60 Data Sheet, Stand-Alone Ethernet Controller with SPI Interface,
DS39662C, 2008 Microchip Technology Inc.
if ENC28J60
config ENC28J60_NINTERFACES
int "Number of physical ENC28J60"
default 1
range 1,1
---help---
Specifies the number of physical ENC28J60
devices that will be supported.
config ENC28J60_SPIMODE
int "SPI mode"
default 0
---help---
Controls the SPI mode. The ENC28J60 spec says that it supports SPI
mode 0,0 only: "The implementation used on this device supports SPI
mode 0,0 only. In addition, the SPI port requires that SCK be at Idle
in a low state; selectable clock polarity is not supported."
However, sometimes you need to tinker with these things.
config ENC28J60_FREQUENCY
int "SPI frequency"
default 20000000
---help---
Define to use a different bus frequency
config ENC28J60_STATS
bool "Network statistics support"
default n
---help---
Collect network statistics
config ENC28J60_HALFDUPPLEX
bool "Enable half dupplex"
default n
---help---
Default is full duplex
config ENC28J60_DUMPPACKET
bool "Dump Packets"
default n
---help---
If selected, the ENC28J60 driver will dump the contents of each
packet to the console.
config ENC28J60_REGDEBUG
bool "Register-Level Debug"
default n
depends on DEBUG && DEBUG_NET
---help---
Enable very low-level register access debug. Depends on DEBUG and DEBUG_NET.
endif
config NET_E1000
bool "E1000 support"
default n
config NET_SLIP
bool "SLIP (serial line) support"
default n
---help---
Reference: RFC 1055
config NET_VNET
bool "VNET support"
default n
|