diff options
Diffstat (limited to 'nuttx/configs/sama5d4-ek/README.txt')
-rw-r--r-- | nuttx/configs/sama5d4-ek/README.txt | 26 |
1 files changed, 13 insertions, 13 deletions
diff --git a/nuttx/configs/sama5d4-ek/README.txt b/nuttx/configs/sama5d4-ek/README.txt index d1f57244b..46a64433a 100644 --- a/nuttx/configs/sama5d4-ek/README.txt +++ b/nuttx/configs/sama5d4-ek/README.txt @@ -560,8 +560,8 @@ Running NuttX from SDRAM advance but instead has to be calculated from the bootloader PLL configuration. See the TODO list at the end of this file for further information. -NuttX Configuration -------------------- + NuttX Configuration + ------------------- In order to run from SDRAM, NuttX must be built at origin 0x20008000 in SDRAM (skipping over SDRAM memory used by the bootloader). The following @@ -577,8 +577,8 @@ NuttX Configuration SDRAM. Since NuttX is already running from SDRAM, it must accept the SDRAM configuration as set up by the bootloader. -Boot sequence -------------- + Boot sequence + ------------- Reference: http://www.at91.com/linux4sam/bin/view/Linux4SAM/GettingStarted @@ -606,8 +606,8 @@ Boot sequence 4. Then NuttX runs from SDRAM -NAND FLASH Memory Map ---------------------- + NAND FLASH Memory Map + --------------------- Reference: http://www.at91.com/linux4sam/bin/view/Linux4SAM/GettingStarted @@ -619,8 +619,8 @@ NAND FLASH Memory Map 0x0020:0000 - 0x007f:ffff: NuttX 0x0080:0000 - end: Available for use as a NAND file system -Programming the AT91Boostrap Binary ------------------------------------ + Programming the AT91Boostrap Binary + ----------------------------------- Reference: http://www.at91.com/linux4sam/bin/view/Linux4SAM/AT91Bootstrap @@ -664,8 +664,8 @@ Programming the AT91Boostrap Binary at91bootstrap binary file and to program the binary to the NandFlash. - Close SAM-BA, remove the USB Device cable. -Programming U-Boot -------------------- + Programming U-Boot + ------------------- Reference http://www.at91.com/linux4sam/bin/view/Linux4SAM/U-Boot @@ -709,8 +709,8 @@ Programming U-Boot You should now be able to interrupt with U-Boot vie the DBGU interface. -Load NuttX with U-Boot on AT91 boards -------------------------------------- + Load NuttX with U-Boot on AT91 boards + ------------------------------------- Reference http://www.at91.com/linux4sam/bin/view/Linux4SAM/U-Boot @@ -3005,7 +3005,7 @@ TM7000 LCD/Touchscreen CONFIG_NX_DISABLE_32BPP=y Graphics Support -> Input Devices -> - CONFIG_NX_XYINPUT=y : Build in mouse/touchscreen support (not used) + CONFIG_NX_XYINPUT=y : Build in mouse/touchscreen support (not used) CONFIG_NX_KBD=y : Build in keyboard support (not used) Graphics Support -> Framed Window Borders -> |