diff options
Diffstat (limited to 'nuttx/configs/stm3240g-eval/ostest/defconfig')
| -rw-r--r-- | nuttx/configs/stm3240g-eval/ostest/defconfig | 12 |
1 files changed, 10 insertions, 2 deletions
diff --git a/nuttx/configs/stm3240g-eval/ostest/defconfig b/nuttx/configs/stm3240g-eval/ostest/defconfig index 2a5443bcb..d95fc96e7 100644 --- a/nuttx/configs/stm3240g-eval/ostest/defconfig +++ b/nuttx/configs/stm3240g-eval/ostest/defconfig @@ -66,7 +66,7 @@ # CONFIG_ARCH_CALIBRATION - Enables some build in instrumentation that # cause a 100 second delay during boot-up. This 100 second delay # serves no purpose other than it allows you to calibrate -# CONFIG_BOARD_LOOPSPERMSEC. You simply use a stop watch to measure +# CONFIG_BOARD_LOOPSPERMSEC. You simply use a stop watch to measure # the 100 second delay then adjust CONFIG_BOARD_LOOPSPERMSEC until # the delay actually is 100 seconds. # CONFIG_ARCH_DMA - Support DMA initialization @@ -678,16 +678,24 @@ CONFIG_FS_READAHEAD=n CONFIG_FS_WRITEBUFFER=n # -# SDIO-based MMC/SD driver +# STM32 SDIO-based MMC/SD driver # # CONFIG_SDIO_DMA # SDIO driver supports DMA +# CONFIG_SDIO_PRI - Select SDIO interrupt prority. Default: 128 +# CONFIG_SDIO_DMAPRIO - Select SDIO DMA interrupt priority. +# Default: Medium +# CONFIG_SDIO_WIDTH_D1_ONLY - Select 1-bit transfer mode. Default: +# 4-bit transfer mode. # CONFIG_MMCSD_MMCSUPPORT # Enable support for MMC cards # CONFIG_MMCSD_HAVECARDDETECT # SDIO driver card detection is 100% accurate # CONFIG_SDIO_DMA=n +#CONFIG_SDIO_PRI=128 +#CONFIG_SDIO_DMAPRIO +#CONFIG_SDIO_WIDTH_D1_ONLY CONFIG_MMCSD_MMCSUPPORT=n CONFIG_MMCSD_HAVECARDDETECT=n |