1 files changed, 62 insertions, 0 deletions
diff --git a/nuttx/configs/zp214xpa/tools/olimex.cfg b/nuttx/configs/zp214xpa/tools/olimex.cfg
new file mode 100755
index 000000000..09f373993
--- /dev/null
+++ b/nuttx/configs/zp214xpa/tools/olimex.cfg
@@ -0,0 +1,62 @@
+# NXP LPC2148  ARM7TDMI
+
+#daemon configuration
+telnet_port 4444
+gdb_port 3333
+
+#interface
+interface ft2232
+ft2232_device_desc "Olimex OpenOCD JTAG A"
+ft2232_layout "olimex-jtag"
+ft2232_vid_pid 0x15BA 0x0003
+
+# Use RCLK. If RCLK is not available fall back to 500kHz.
+#
+# Depending on cabling you might be able to eek this up to 2000kHz.
+jtag_rclk 500
+
+if { [info exists CHIPNAME] } {
+   set _CHIPNAME $CHIPNAME
+} else {
+   set _CHIPNAME lpc2148
+}
+
+if { [info exists CPUTAPID ] } {
+   set _CPUTAPID $CPUTAPID
+} else {
+   set _CPUTAPID 0x4f1f0f0f
+}
+
+adapter_nsrst_delay 200
+jtag_ntrst_delay 200
+
+# NOTE!!! LPCs need reset pulled while RTCK is low. 0 to activate
+# JTAG, power-on reset is not enough, i.e. you need to perform a
+# reset before being able to talk to the LPC2148, attach is not possible.
+
+reset_config trst_and_srst
+
+jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID
+
+set _TARGETNAME $_CHIPNAME.cpu
+target create $_TARGETNAME arm7tdmi -chain-position $_TARGETNAME
+
+$_TARGETNAME configure -work-area-phys 0x40000000 -work-area-size 0x4000 -work-area-backup 0
+
+$_TARGETNAME configure -event reset-init {
+	# Force target into ARM state
+	arm core_state arm
+
+	# Do not remap 0x0000-0x0020 to anything but the flash (i.e. select
+	# "User Flash Mode" where interrupt vectors are _not_ remapped,
+	# and reside in flash instead).
+	#
+	# See section 7.1 on page 32 ("Memory Mapping control register") in
+	# "UM10139: Volume 1: LPC214x User Manual", Rev. 02 -- 25 July 2006.
+	# http://www.standardics.nxp.com/support/documents/microcontrollers/pdf/user.manual.lpc2141.lpc2142.lpc2144.lpc2146.lpc2148.pdf
+	mwb 0xE01FC040 0x01
+}
+
+# flash bank <name> lpc2000 <base> <size> 0 0 <target#> <variant> <clock> [calc checksum]
+set _FLASHNAME $_CHIPNAME.flash
+flash bank $_FLASHNAME lpc2000 0x0 0x7d000 0 0 $_TARGETNAME lpc2000_v2 14765 calc_checksum