1 files changed, 50 insertions, 0 deletions
diff --git a/misc/Obsoleted/configs/16z/nsh/README.txt b/misc/Obsoleted/configs/16z/nsh/README.txt
new file mode 100644
index 000000000..b772f43a9
--- /dev/null
+++ b/misc/Obsoleted/configs/16z/nsh/README.txt
@@ -0,0 +1,50 @@
+README.txt
+==========
+
+Contents
+--------
+
+  o NSH Project
+  o Loading and Executing Code
+  o Console Output
+  o STATUS
+
+NSH Project
+-----------
+
+nsh.zfpproj is a simple ZDS II - ZNEO 5.0.1 project that will allow you
+  to use the ZDS-II debugger.  Before using, copy the following files from
+  the toplevel directory:
+
+    nuttx.hex, nuttx.map, nuttx.lod
+
+  to this directory as:
+
+    nsh.hex, nsh.map, nsh.lod
+
+Loading and Executing Code
+--------------------------
+
+1. Copy the files to this directory as described above
+2. Connect the ZiLOG XTools USB debugger.
+3. Install the USB driver from the ZDS-II device_drivers directory
+4. Start ZDS-II and load the nsh.zfpproj project
+5. In the debug tab, connect to the debugger
+6. In the debug tab, load code, reset, and go
+
+Console Output
+--------------
+
+Interaction with NSH is via the serial console at 57600 8N1 baud.
+
+STATUS
+------
+1. Note that you must apply the ZNEO patch if you are using ZDS-II 5.0.1.
+   See the README.txt file in the parent directory for more information.
+
+2. This configuration does not run correctly.  There is currently a problem
+   with the SRAM accesses.
+
+3. I bet that this code, like ostest, will not run if started by a hardware
+   reset.  It may only run when started via the debugger.
+