path: root/ROMFS/px4fmu_common/init.d/1000_rc_fw_easystar.hil

#!nsh
#
# USB HIL start
#

echo "[HIL] HILStar starting.."

#
# Load default params for this platform
#
if param compare SYS_AUTOCONFIG 1
then
	# Set all params here, then disable autoconfig
	
	param set FW_P_D 0
	param set FW_P_I 0
	param set FW_P_IMAX 15
	param set FW_P_LIM_MAX 50
	param set FW_P_LIM_MIN -50
	param set FW_P_P 60
	param set FW_P_RMAX_NEG 0
	param set FW_P_RMAX_POS 0
	param set FW_P_ROLLFF 1.1
	param set FW_R_D 0
	param set FW_R_I 5
	param set FW_R_IMAX 20
	param set FW_R_P 100
	param set FW_R_RMAX 100
	param set FW_THR_CRUISE 0.65
	param set FW_THR_MAX 1
	param set FW_THR_MIN 0
	param set FW_T_SINK_MAX 5.0
	param set FW_T_SINK_MIN 4.0
	param set FW_Y_ROLLFF 1.1
	param set FW_L1_PERIOD 16
	param set RC_SCALE_ROLL 1.0
	param set RC_SCALE_PITCH 1.0

	param set SYS_AUTOCONFIG 0
	param save
fi

# Allow USB some time to come up
sleep 1
# Tell MAVLink that this link is "fast"
mavlink start -b 230400 -d /dev/ttyACM0

# Create a fake HIL /dev/pwm_output interface
hil mode_pwm

#
# Force some key parameters to sane values
# MAV_TYPE     1 = fixed wing, 2 = quadrotor, 13 = hexarotor
#              see https://pixhawk.ethz.ch/mavlink/
#
param set MAV_TYPE 1

#
# Check if we got an IO
#
if px4io start
then
	echo "IO started"
else
	fmu mode_serial
	echo "FMU started"
fi

#
# Start the sensors (depends on orb, px4io)
#
sh /etc/init.d/rc.sensors

#
# Start the attitude estimator (depends on orb)
#
att_pos_estimator_ekf start
 
#
# Load mixer and start controllers (depends on px4io)
#
mixer load /dev/pwm_output /etc/mixers/FMU_AET.mix
fw_pos_control_l1 start
fw_att_control start

echo "[HIL] setup done, running"