diff options
Diffstat (limited to 'src/modules/uORB/topics/vehicle_command.h')
| -rw-r--r-- | src/modules/uORB/topics/vehicle_command.h | 3 |
1 files changed, 3 insertions, 0 deletions
diff --git a/src/modules/uORB/topics/vehicle_command.h b/src/modules/uORB/topics/vehicle_command.h index 44aa50572..f264accbb 100644 --- a/src/modules/uORB/topics/vehicle_command.h +++ b/src/modules/uORB/topics/vehicle_command.h @@ -65,6 +65,9 @@ enum VEHICLE_CMD { VEHICLE_CMD_NAV_TAKEOFF = 22, /* Takeoff from ground / hand |Minimum pitch (if airspeed sensor present), desired pitch without sensor| Empty| Empty| Yaw angle (if magnetometer present), ignored without magnetometer| Latitude| Longitude| Altitude| */ VEHICLE_CMD_NAV_ROI = 80, /* Sets the region of interest (ROI) for a sensor set or the vehicle itself. This can then be used by the vehicles control system to control the vehicle attitude and the attitude of various sensors such as cameras. |Region of intereset mode. (see MAV_ROI enum)| MISSION index/ target ID. (see MAV_ROI enum)| ROI index (allows a vehicle to manage multiple ROI's)| Empty| x the location of the fixed ROI (see MAV_FRAME)| y| z| */ VEHICLE_CMD_NAV_PATHPLANNING = 81, /* Control autonomous path planning on the MAV. |0: Disable local obstacle avoidance / local path planning (without resetting map), 1: Enable local path planning, 2: Enable and reset local path planning| 0: Disable full path planning (without resetting map), 1: Enable, 2: Enable and reset map/occupancy grid, 3: Enable and reset planned route, but not occupancy grid| Empty| Yaw angle at goal, in compass degrees, [0..360]| Latitude/X of goal| Longitude/Y of goal| Altitude/Z of goal| */ + VEHICLE_CMD_NAV_GUIDED_LIMITS=90, /* set limits for external control |timeout - maximum time (in seconds) that external controller will be allowed to control vehicle. 0 means no timeout| absolute altitude min (in meters, WGS84) - if vehicle moves below this alt, the command will be aborted and the mission will continue. 0 means no lower altitude limit| absolute altitude max (in meters)- if vehicle moves above this alt, the command will be aborted and the mission will continue. 0 means no upper altitude limit| horizontal move limit (in meters, WGS84) - if vehicle moves more than this distance from it's location at the moment the command was executed, the command will be aborted and the mission will continue. 0 means no horizontal altitude limit| Empty| Empty| Empty| */ + VEHICLE_CMD_NAV_GUIDED_MASTER=91, /* set id of master controller |System ID| Component ID| Empty| Empty| Empty| Empty| Empty| */ + VEHICLE_CMD_NAV_GUIDED_ENABLE=92, /* hand control over to an external controller |On / Off (> 0.5f on)| Empty| Empty| Empty| Empty| Empty| Empty| */ VEHICLE_CMD_NAV_LAST = 95, /* NOP - This command is only used to mark the upper limit of the NAV/ACTION commands in the enumeration |Empty| Empty| Empty| Empty| Empty| Empty| Empty| */ VEHICLE_CMD_CONDITION_DELAY = 112, /* Delay mission state machine. |Delay in seconds (decimal)| Empty| Empty| Empty| Empty| Empty| Empty| */ VEHICLE_CMD_CONDITION_CHANGE_ALT = 113, /* Ascend/descend at rate. Delay mission state machine until desired altitude reached. |Descent / Ascend rate (m/s)| Empty| Empty| Empty| Empty| Empty| Finish Altitude| */ |