|
|
/************************************************************************************
* arch/arm/src/stm32/chip/stm32_flash.h
*
* Copyright (C) 2009, 2011 Gregory Nutt. All rights reserved.
* Author: Gregory Nutt <gnutt@nuttx.org>
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
*
* 1. Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
* 2. Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in
* the documentation and/or other materials provided with the
* distribution.
* 3. Neither the name NuttX nor the names of its contributors may be
* used to endorse or promote products derived from this software
* without specific prior written permission.
*
* THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
* "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
* LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS
* FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE
* COPYRIGHT OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT,
* INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING,
* BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS
* OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED
* AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
* LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN
* ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
* POSSIBILITY OF SUCH DAMAGE.
*
************************************************************************************/
#ifndef __ARCH_ARM_SRC_STM32_CHIP_STM32_FLASH_H
#define __ARCH_ARM_SRC_STM32_CHIP_STM32_FLASH_H
/************************************************************************************
* Pre-processor Definitions
************************************************************************************/
#ifdef defined(CONFIG_STM32_LOWDENSITY)
# define STM32_FLASH_NPAGES 32
# define STM32_FLASH_PAGESIZE 1024
#elif defined(CONFIG_STM32_MEDIUMDENSITY)
# define STM32_FLASH_NPAGES 128
# define STM32_FLASH_PAGESIZE 1024
#elif defined(CONFIG_STM32_CONNECTIVITYLINE)
# define STM32_FLASH_NPAGES 128
# define STM32_FLASH_PAGESIZE 2048
#elif defined(CONFIG_STM32_HIGHDENSITY)
# define STM32_FLASH_NPAGES 256
# define STM32_FLASH_PAGESIZE 2048
#elif defined(CONFIG_STM32_STM32F40XX)
# define STM32_FLASH_NPAGES 8
# define CONFIG_STM32_STM32F40XX (128*1024)
#endif
#define STM32_FLASH_SIZE (STM32_FLASH_NPAGES * STM32_FLASH_PAGESIZE)
/* Register Offsets *****************************************************************/
#define STM32_FLASH_ACR_OFFSET 0x0000
#define STM32_FLASH_KEYR_OFFSET 0x0004
#define STM32_FLASH_OPTKEYR_OFFSET 0x0008
#define STM32_FLASH_SR_OFFSET 0x000c
#define STM32_FLASH_CR_OFFSET 0x0010
#if defined(CONFIG_STM32_STM32F10XX)
# define STM32_FLASH_AR_OFFSET 0x0014
# define STM32_FLASH_OBR_OFFSET 0x001c
# define STM32_FLASH_WRPR_OFFSET 0x0020
#elif defined(CONFIG_STM32_STM32F40XX)
# define STM32_FLASH_OPTCR_OFFSET 0x0014
#endif
/* Register Addresses ***************************************************************/
#define STM32_FLASH_ACR (STM32_FLASHIF_BASE+STM32_FLASH_ACR_OFFSET)
#define STM32_FLASH_KEYR (STM32_FLASHIF_BASE+STM32_FLASH_KEYR_OFFSET)
#define STM32_FLASH_OPTKEYR (STM32_FLASHIF_BASE+STM32_FLASH_OPTKEYR_OFFSET)
#define STM32_FLASH_SR (STM32_FLASHIF_BASE+STM32_FLASH_SR_OFFSET)
#define STM32_FLASH_CR (STM32_FLASHIF_BASE+STM32_FLASH_CR_OFFSET)
#if defined(CONFIG_STM32_STM32F10XX)
# define STM32_FLASH_AR (STM32_FLASHIF_BASE+STM32_FLASH_AR_OFFSET)
# define STM32_FLASH_OBR (STM32_FLASHIF_BASE+STM32_FLASH_OBR_OFFSET)
# define STM32_FLASH_WRPR (STM32_FLASHIF_BASE+STM32_FLASH_WRPR_OFFSET)
#elif defined(CONFIG_STM32_STM32F40XX)
# define STM32_FLASH_OPTCR (STM32_FLASHIF_BASE+STM32_FLASH_OPTCR_OFFSET)
#endif
/* Register Bitfield Definitions ****************************************************/
/* Flash Access Control Register (ACR) */
#define FLASH_ACR_LATENCY_SHIFT (0)
#define FLASH_ACR_LATENCY_MASK (7 << FLASH_ACR_LATENCY_SHIFT)
# define FLASH_ACR_LATENCY(n) ((n) << FLASH_ACR_LATENCY_SHIFT) /* n wait states */
# define FLASH_ACR_LATENCY_0 (0 << FLASH_ACR_LATENCY_SHIFT) /* 000: Zero wait states */
# define FLASH_ACR_LATENCY_1 (1 << FLASH_ACR_LATENCY_SHIFT) /* 001: One wait state */
# define FLASH_ACR_LATENCY_2 (2 << FLASH_ACR_LATENCY_SHIFT) /* 010: Two wait states */
# define FLASH_ACR_LATENCY_3 (3 << FLASH_ACR_LATENCY_SHIFT) /* 011: Three wait states */
# define FLASH_ACR_LATENCY_4 (4 << FLASH_ACR_LATENCY_SHIFT) /* 100: Four wait states */
# define FLASH_ACR_LATENCY_5 (5 << FLASH_ACR_LATENCY_SHIFT) /* 101: Five wait states */
# define FLASH_ACR_LATENCY_6 (6 << FLASH_ACR_LATENCY_SHIFT) /* 110: Six wait states */
# define FLASH_ACR_LATENCY_7 (7 << FLASH_ACR_LATENCY_SHIFT) /* 111: Seven wait states */
#if defined(CONFIG_STM32_STM32F10XX)
# define FLASH_ACR_HLFCYA (1 << 3) /* FLASH half cycle access */
# define FLASH_ACR_PRTFBE (1 << 4) /* FLASH prefetch enable */
#elif defined(CONFIG_STM32_STM32F40XX)
# define FLASH_ACR_ICEN (1 << 9) /* Bit 9: Instruction cache enable */
# define FLASH_ACR_DCEN (1 << 10) /* Bit 10: Data cache enable */
# define FLASH_ACR_ICRST (1 << 11) /* Bit 11: Instruction cache reset */
# define FLASH_ACR_DCRST (1 << 12) /* Bit 12: Data cache reset */
#endif
/* Flash Status Register (SR) */
#if defined(CONFIG_STM32_STM32F10XX)
# define FLASH_SR_BSY (1 << 0) /* Busy */
# define FLASH_SR_PGERR (1 << 2) /* Programming Error */
# define FLASH_SR_WRPRT_ERR (1 << 4) /* Write Protection Error */
# define FLASH_SR_EOP (1 << 5) /* End of Operation */
#elif defined(CONFIG_STM32_STM32F40XX)
# define FLASH_SR_EOP (1 << 0) /* Bit 0: End of operation */
# define FLASH_SR_OPERR (1 << 1) /* Bit 1: Operation error */
# define FLASH_SR_WRPERR (1 << 4) /* Bit 4: Write protection error */
# define FLASH_SR_PGAERR (1 << 5) /* Bit 5: Programming alignment error */
# define FLASH_SR_PGPERR (1 << 6) /* Bit 6: Programming parallelism error */
# define FLASH_SR_PGSERR (1 << 7) /* Bit 7: Programming sequence error */
# define FLASH_SR_BSY (1 << 16) /* Bit 16: Busy */
#endif
/* Flash Control Register (CR) */
#if defined(CONFIG_STM32_STM32F10XX)
# define FLASH_CR_PG (1 << 0) /* Program Page */
# define FLASH_CR_PER (1 << 1) /* Page Erase */
# define FLASH_CR_MER (1 << 2) /* Mass Erase */
# define FLASH_CR_OPTPG (1 << 4) /* Option Byte Programming */
# define FLASH_CR_OPTER (1 << 5) /* Option Byte Erase */
# define FLASH_CR_STRT (1 << 6) /* Start Erase */
# define FLASH_CR_LOCK (1 << 7) /* Page Locked or Lock Page */
# define FLASH_CR_OPTWRE (1 << 9) /* Option Bytes Write Enable */
# define FLASH_CR_ERRIE (1 << 10) /* Error Interrupt Enable */
# define FLASH_CR_EOPIE (1 << 12) /* End of Program Interrupt Enable */
#elif defined(CONFIG_STM32_STM32F40XX)
# define FLASH_CR_PG (1 << 0) /* Bit 0: Programming */
# define FLASH_CR_SER (1 << 1) /* Bit 1: Sector Erase */
# define FLASH_CR_MER (1 << 2) /* Bit 2: Mass Erase */
# define FLASH_CR_SNB_SHIFT (3) /* Bits 3-6: Sector number */
# define FLASH_CR_SNB_MASK (15 << FLASH_CR_SNB_SHIFT)
# define FLASH_CR_SNB(n) ((n) << FLASH_CR_SNB_SHIFT) /* Sector n, n=0..11 */
# define FLASH_CR_PSIZE_SHIFT (8) /* Bits 8-9: Program size */
# define FLASH_CR_PSIZE_MASK (3 << FLASH_CR_PSIZE_SHIFT)
# define FLASH_CR_PSIZE_X8 (0 << FLASH_CR_PSIZE_SHIFT) /* 00 program x8 */
# define FLASH_CR_PSIZE_X16 (1 << FLASH_CR_PSIZE_SHIFT) /* 01 program x16 */
# define FLASH_CR_PSIZE_X32 (2 << FLASH_CR_PSIZE_SHIFT) /* 10 program x32 */
# define FLASH_CR_PSIZE_X64 (3 << FLASH_CR_PSIZE_SHIFT) /* 11 program x64 */
# define FLASH_CR_EOPIE (1 << 24) /* Bit 24: End of operation interrupt enable */
# define FLASH_CR_ERRIE (1 << 25) /* Bit 25: Error interrupt enable */
# define FLASH_CR_LOCK (1 << 31) /* Bit 31: Lock */
#endif
/* Flash Option Control Register (OPTCR) */
#if defined(CONFIG_STM32_STM32F40XX)
# define FLASH_OPTCR_OPTLOCK (1 << 0) /* Bit 0: Option lock */
# define FLASH_OPTCR_OPTSTRT (1 << 1) /* Bit 1: Option start */
# define FLASH_OPTCR_BORLEV_SHIFT (2) /* Bits 2-3: BOR reset Level */
# define FLASH_OPTCR_BORLEV_MASK (3 << FLASH_OPTCR_BORLEV_SHIFT)
# define FLASH_OPTCR_VBOR3 (0 << FLASH_OPTCR_BORLEV_SHIFT) /* 00: BOR Level 3 */
# define FLASH_OPTCR_VBOR2 (1 << FLASH_OPTCR_BORLEV_SHIFT) /* 01: BOR Level 2 */
# define FLASH_OPTCR_VBOR1 (2 << FLASH_OPTCR_BORLEV_SHIFT) /* 10: BOR Level 1 */
# define FLASH_OPTCR_VBOR0 (3 << FLASH_OPTCR_BORLEV_SHIFT) /* 11: BOR off */
# define FLASH_OPTCR_USER_SHIFT (5) /* Bits 5-7: User option bytes */
# define FLASH_OPTCR_USER_MASK (7 << FLASH_OPTCR_USER_SHIFT)
# define FLASH_OPTCR_NRST_STDBY (1 << 7) /* Bit 7: nRST_STDBY */
# define FLASH_OPTCR_NRST_STOP (1 << 6) /* Bit 6: nRST_STOP */
# define FLASH_OPTCR_WDG_SW (1 << 5) /* Bit 5: WDG_SW */
# define FLASH_OPTCR_RDP_SHIFT (8) /* Bits 8-15: Read protect */
# define FLASH_OPTCR_RDP_MASK (0xff << FLASH_OPTCR_RDP_SHIFT)
# define FLASH_OPTCR_NWRP_SHIFT (16) /* Bits 16-27: Not write protect */
# define FLASH_OPTCR_NWRP_MASK (0xfff << FLASH_OPTCR_NWRP_SHIFT)
#endif
#endif /* __ARCH_ARM_SRC_STM32_CHIP_STM32_FLASH_H */
|