blob: 001d032285afc0ec3e18ac808f917390161a6180 (
plain) (
tree)
|
|
#
# For a description of the syntax of this configuration file,
# see misc/tools/kconfig-language.txt.
#
if ARCH_MIPS
choice
prompt "MIPS chip selection"
default ARCH_CHIP_PIC32MX
config ARCH_CHIP_PIC32MX
bool "PIC32MX"
---help---
Microchip PIC32MX320F032H (MIPS32)
endchoice
config ARCH_MIPS32
bool
default y if ARCH_CHIP_PIC32MX
config ARCH_FAMILY
string
default "mips32" if ARCH_MIPS32
config ARCH_CHIP
string
default "pic32mx" if ARCH_CHIP_PIC32MX
config ARCH_LEDS
bool "Use board LEDs to show state"
default y
---help---
Use LEDs to show state. Unique to boards that have LEDs
config ARCH_INTERRUPTSTACK
bool "Use interrupt stack"
default y
---help---
This architecture supports an interrupt stack. If defined, this symbol
is the size of the interrupt stack in bytes. If not defined, the user
task stacks will be used during interrupt handling.
config ARCH_IRQPRIO
bool "Interrupt priority"
default y if ARCH_CHIP_PIC32MX
---help---
Select if your board supports interrupt prioritization.
config ARCH_LOOPSPERMSEC
int "Delay loops per millisecond"
default 5000
---help---
Delay loops nust be calibrated for correct operation.
config ARCH_CALIBRATION
bool "Calibrate delay loop"
default n
---help---
Enables some built in instrumentation that causes a 100 second delay
during boot-up. This 100 second delay serves no purpose other than it
allows you to calibratre ARCH_LOOPSPERMSEC. You simply use a stop
watch to measure the 100 second delay then adjust ARCH_LOOPSPERMSEC until
the delay actually is 100 seconds.
source arch/mips/src/common/Kconfig
source arch/mips/src/mips32/Kconfig
source arch/mips/src/pic32mx/Kconfig
endif
|