diff options
Diffstat (limited to 'nuttx/configs/mirtoo/README.txt')
| -rw-r--r-- | nuttx/configs/mirtoo/README.txt | 40 |
1 files changed, 39 insertions, 1 deletions
diff --git a/nuttx/configs/mirtoo/README.txt b/nuttx/configs/mirtoo/README.txt index 52350bb05..7de835d68 100644 --- a/nuttx/configs/mirtoo/README.txt +++ b/nuttx/configs/mirtoo/README.txt @@ -375,6 +375,24 @@ Toolchains Note that the tools will have the prefix, mypic32- so, for example, the compiler will be called mypic32-gcc. + Penguino mips-elf Toolchain + --------------------------- + + Another option is the mips-elf toolchain used with the Penguino project. This + is a relatively current mips-elf GCC and should provide free C++ support as + well. This toolchain can be downloded from the Penguino website: + http://wiki.pinguino.cc/index.php/Main_Page#Download . There is some general + information about using the Penguino mips-elf toolchain in this thread: + http://tech.groups.yahoo.com/group/nuttx/message/1821 + + Experimental (and untested) support for the Penguino mips-elf toolchain has + been included in the Mirtoo configurations. Use this configuration option to + select the Penguino mips-elf toolchain: + + CONFIG_PIC32MX_MIPSELFL - Penguino mips-elf toolchain for Linux + + And set the path appropriately in the setenv.sh file. And good luck! + MPLAB/C32 vs MPLABX/X32 ----------------------- @@ -771,11 +789,31 @@ Where <subdir> is one of the following: This configuration also uses the Microchip C32 toolchain under windows by default: - CONFIG_PIC32MX_MICROCHIPW_LITE=y : Lite version of widows toolchain + CONFIG_PIC32MX_MICROCHIPW_LITE=y : Lite version of windows toolchain To switch to the Linux C32 toolchain you will have to change (1) the toolchain selection in .config (after configuration) and (2) the path to the toolchain in setenv.sh. See notes above with regard to the XC32 toolchain. + nsh: + This configuration directory holds configuration files tht can + be used to support the NuttShell (NSH). This configuration use + UART1 which is available on FUNC 4 and 5 on connector X3: + + CONFIG_PIC32MX_UART1=y : UART1 for serial console + CONFIG_UART1_SERIAL_CONSOLE=n + + If you are not using MPLAB to debug, you may switch to UART2 + by following the instructions above for the ostest configuration. + + This configuration also uses the Microchip C32 toolchain under + windows by default: + CONFIG_PIC32MX_MICROCHIPW_LITE=y : Lite version of windows toolchain + + To switch to the Linux C32 toolchain you will have to change (1) the + toolchain selection in .config (after configuration) and (2) the + path to the toolchain in setenv.sh. See notes above with regard to + the XC32 toolchain. + |