diff options
Diffstat (limited to 'nuttx/configs/olimex-strp711/README.txt')
| -rw-r--r-- | nuttx/configs/olimex-strp711/README.txt | 46 |
1 files changed, 32 insertions, 14 deletions
diff --git a/nuttx/configs/olimex-strp711/README.txt b/nuttx/configs/olimex-strp711/README.txt index 126969ca0..425613673 100644 --- a/nuttx/configs/olimex-strp711/README.txt +++ b/nuttx/configs/olimex-strp711/README.txt @@ -372,24 +372,43 @@ ENC28J60 Module the ENC28J60 (And I don't have the correct wall wart to power the the board). -Configurations: ---------------- +Common Configuration Notes: +--------------------------- - nettest: - This configuration directory may be used to enable networking using the - an Microchip ENC28J60 SPI Ethernet module (see above for connection to - STR-P711). + 1. Each Olimex STRP711 configuration is maintained in a sub-directory and + can be selected as follow: + + cd tools + ./configure.sh olimex-strp711/<subdir> + cd - + . ./setenv.sh + + Where <subdir> is one of the configuration sub-directories described in + the following paragraph. + + 2. These configurations use the mconf-based configuration tool. To + change a configurations using that tool, you should: - NOTES: + a. Build and install the kconfig-mconf tool. See nuttx/README.txt + and misc/tools/ - 1. This configuration uses the mconf-based configuration tool. To - change this configurations using that tool, you should: + b. Execute 'make menuconfig' in nuttx/ in order to start the + reconfiguration process. - a. Build and install the kconfig-mconf tool. See nuttx/README.txt - and misc/tools/ + 3. By default, all configurations assume the NuttX Buildroot toolchain + under Linux (should work under Windows with Cygwin as well). This + is easily reconfigured: - b. Execute 'make menuconfig' in nuttx/ in order to start the - reconfiguration process. + CONFIG_HOST_LINUX=y + CONFIG_ARM_TOOLCHAIN_BUILDROOT=y + +Configuration Sub-Directories: +------------------------------ + + nettest: + This configuration directory may be used to enable networking using the + an Microchip ENC28J60 SPI Ethernet module (see above for connection to + STR-P711). nsh: Configures the NuttShell (nsh) located at examples/nsh. The @@ -432,4 +451,3 @@ STR71x-Specific Configuration Settings CONFIG_UARTn_BITS - The number of bits. Must be either 7 or 8. CONFIG_UARTn_PARTIY - 0=no parity, 1=odd parity, 2=even parity, 3=mark 1, 4=space 0 CONFIG_UARTn_2STOP - Two stop bits - |