diff options
Diffstat (limited to 'nuttx/configs/stm3210e-eval/README.txt')
-rw-r--r-- | nuttx/configs/stm3210e-eval/README.txt | 38 |
1 files changed, 24 insertions, 14 deletions
diff --git a/nuttx/configs/stm3210e-eval/README.txt b/nuttx/configs/stm3210e-eval/README.txt index 11e1cca25..b7f6192a5 100644 --- a/nuttx/configs/stm3210e-eval/README.txt +++ b/nuttx/configs/stm3210e-eval/README.txt @@ -714,8 +714,9 @@ Where <subdir> is one of the following: =========== ======================= ================================ nsh nsh2 =========== ======================= ================================ - Toolchain: NuttX buildroot for Codesourcery for Windows (1) - Linux or Cygwin (1,2) + Platform Windows with Cygwin (2) Windows with Cygwin (2) + ----------- ----------------------- -------------------------------- + Toolchain: NuttX buildroot (1) Codesourcery for Windows (1) ----------- ----------------------- -------------------------------- Loader: DfuSe DfuSe ----------- ----------------------- -------------------------------- @@ -769,22 +770,31 @@ Where <subdir> is one of the following: Failure to do this could result in corruption of the SD card format. - The nsh2 contains support for some built-in applications that can be - enabled by make some additional minor changes: + 1. Both configurations use the mconf-based configuration tool. To + change these configurations using that tool, you should: + + a. Build and install the kconfig-mconf tool. See nuttx/README.txt + and misc/tools/ + + b. Execute 'make menuconfig' in nuttx/ in order to start the + reconfiguration process. + + 2. The nsh2 contains support for some built-in applications that can be + enabled by make some additional minor changes: - (1) examples/can. The CAN test example can be enabled by changing the - following settings in nsh2/defconfig: + a. examples/can. The CAN test example can be enabled by changing the + following settings in nsh2/defconfig: - CONFIG_CAN=y # Enable CAN "upper-half" driver support - CONFIG_STM32_CAN1=y # Enable STM32 CAN1 "lower-half" driver support + CONFIG_CAN=y # Enable CAN "upper-half" driver support + CONFIG_STM32_CAN1=y # Enable STM32 CAN1 "lower-half" driver support - The default CAN settings may need to change in your board board - configuration: + The default CAN settings may need to change in your board board + configuration: - CONFIG_CAN_EXTID=y # Support extended IDs - CONFIG_CAN1_BAUD=250000 # Bit rate: 250 KHz - CONFIG_CAN_TSEG1=12 # 80% sample point - CONFIG_CAN_TSEG2=3 + CONFIG_CAN_EXTID=y # Support extended IDs + CONFIG_CAN1_BAUD=250000 # Bit rate: 250 KHz + CONFIG_CAN_TSEG1=12 # 80% sample point + CONFIG_CAN_TSEG2=3 nx: --- An example using the NuttX graphics system (NX). This example |