diff options
Diffstat (limited to 'nuttx/configs/vsn/src/vsn.h')
-rw-r--r-- | nuttx/configs/vsn/src/vsn.h | 16 |
1 files changed, 8 insertions, 8 deletions
diff --git a/nuttx/configs/vsn/src/vsn.h b/nuttx/configs/vsn/src/vsn.h index f8414f36c..e84f0acb4 100644 --- a/nuttx/configs/vsn/src/vsn.h +++ b/nuttx/configs/vsn/src/vsn.h @@ -51,12 +51,12 @@ /************************************************************************************ * PIN Definitions ************************************************************************************/ - + /* Board Peripheral Assignment - * + * * RS232/Power connector: * - USART1, is the default bootloader and console - * + * * Sensor Connector: * Digital: * - GPIOs: PB10, PB11 (or even TIM2 CH3 and CH4) @@ -70,14 +70,14 @@ * - Filtered Out (TIM3_CH4) * (TIM8 could run at lower frequency, while TIM3 must run at highest possible) * - Gain selection muxed with SDcard I/Os. - * + * * Radio connector: * - UART3 / UART4 * - SPI2 * - I2C1 (remapped pins vs. Expansion connector) * - CAN * - TIM4 CH[3:4] - * + * * Expansion connector: * - WakeUp Pin * - System Wide Reset @@ -88,7 +88,7 @@ * - ADC2 on pins [0:7] * - TIM2 Channels [1:4] * - TIM5 Channels [1:4] - * + * * Onboard Components: * - SPI3 has direct connection with FRAM * - SDCard, conencts the microSD and shares the control lines with Sensor Interface @@ -100,7 +100,7 @@ /* LED */ #define GPIO_LED (GPIO_OUTPUT|GPIO_CNF_OUTPP |GPIO_MODE_2MHz |GPIO_PORTB|GPIO_PIN2 |GPIO_OUTPUT_CLEAR) - + /* BUTTON - Note that after a good second button causes hardware reset */ #define GPIO_PUSHBUTTON (GPIO_INPUT |GPIO_CNF_INFLOAT |GPIO_MODE_INPUT|GPIO_PORTC|GPIO_PIN5 ) @@ -148,7 +148,7 @@ #define GPIO_OUT_HIGH (GPIO_OUTPUT|GPIO_CNF_OUTPP |GPIO_MODE_2MHz |GPIO_PORTB|GPIO_PIN1 |GPIO_OUTPUT_SET) #define GPIO_OUT_AIN (GPIO_INPUT |GPIO_CNF_ANALOGIN |GPIO_MODE_INPUT|GPIO_PORTB|GPIO_PIN1 ) #define GPIO_OUT_PWM (GPIO_ALT |GPIO_CNF_AFPP |GPIO_MODE_10MHz|GPIO_PORTB|GPIO_PIN1 ) -#define GPIO_OUT_PWM_TIM3_CH 4 /* TIM3.CH4 */ +#define GPIO_OUT_PWM_TIM3_CH 4 /* TIM3.CH4 */ #define GPIO_PGIA_A0_H (GPIO_OUTPUT|GPIO_CNF_OUTPP |GPIO_MODE_2MHz |GPIO_PORTC|GPIO_PIN8 |GPIO_OUTPUT_SET) #define GPIO_PGIA_A0_L (GPIO_OUTPUT|GPIO_CNF_OUTPP |GPIO_MODE_2MHz |GPIO_PORTC|GPIO_PIN8 |GPIO_OUTPUT_CLEAR) |