1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
|
/************************************************************************************
* configs/sama5d4-ek/src/sam_ethernet.c
*
* Copyright (C) 2014 Gregory Nutt. All rights reserved.
* Author: Gregory Nutt <gnutt@nuttx.org>
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
*
* 1. Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
* 2. Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in
* the documentation and/or other materials provided with the
* distribution.
* 3. Neither the name NuttX nor the names of its contributors may be
* used to endorse or promote products derived from this software
* without specific prior written permission.
*
* THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
* "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
* LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS
* FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE
* COPYRIGHT OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT,
* INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING,
* BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS
* OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED
* AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
* LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN
* ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
* POSSIBILITY OF SUCH DAMAGE.
*
************************************************************************************/
/************************************************************************************
* Included Files
************************************************************************************/
#include <nuttx/config.h>
#include <string.h>
#include <assert.h>
#include <debug.h>
#include <nuttx/irq.h>
#include <nuttx/arch.h>
#include "sam_pio.h"
#include "sam_ethernet.h"
#include "sama5d4-ek.h"
#ifdef HAVE_NETWORK
/************************************************************************************
* Pre-processor Definitions
************************************************************************************/
#ifndef CONFIG_SAMA5_EMAC0
# undef CONFIG_SAMA5_EMAC0_ISETH0
#endif
#ifdef CONFIG_SAMA5_EMAC0_ISETH0
# define SAMA5_EMAC0_DEVNAME "eth0"
# define SAMA5_EMAC1_DEVNAME "eth1"
#else
# define SAMA5_EMAC0_DEVNAME "eth1"
# define SAMA5_EMAC1_DEVNAME "eth0"
#endif
/************************************************************************************
* Private Data
************************************************************************************/
#ifdef CONFIG_SAMA5_PIOE_IRQ
#ifdef CONFIG_SAMA5_EMAC0
static xcpt_t g_emac0_handler;
#endif
#ifdef CONFIG_SAMA5_EMAC1
static xcpt_t g_emac1_handler;
#endif
#endif
/************************************************************************************
* Private Functions
************************************************************************************/
/************************************************************************************
* Public Functions
************************************************************************************/
/************************************************************************************
* Name: sam_netinitialize
*
* Description:
* Configure board resources to support networking.
*
************************************************************************************/
void weak_function sam_netinitialize(void)
{
#ifdef CONFIG_SAMA5_EMAC0
sam_configpio(PIO_INT_ETH0);
#endif
#ifdef CONFIG_SAMA5_EMAC1
sam_configpio(PIO_INT_ETH1);
#endif
}
/****************************************************************************
* Name: arch_phy_irq
*
* Description:
* This function may be called to register an interrupt handler that will
* be called when a PHY interrupt occurs. This function both attaches
* the interrupt handler and enables the interrupt if 'handler' is non-
* NULL. If handler is NULL, then the interrupt is detached and disabled
* instead.
*
* This interrupt may or may not be available on a given platform depending
* on how the network hardware architecture is implemented. In a typical
* case, the PHY interrupt is provided to board-level logic as a GPIO
* interrupt (in which case this is a board-specific interface and really
* should be called board_phy_irq()); In other cases, the PHY interrupt
* may be cause by the chip's MAC logic (in which case arch_phy_irq()) is
* an appropriate name. Other other boards, there may be no PHY interrupts
* available at all. If client attachable PHY interrupts are available
* from the board or from the chip, then CONFIG_ARCH_PHY_INTERRUPT should
* be defined to indicate that fact.
*
* Typical usage:
* a. OS service logic (not application logic*) attaches to the PHY
* PHY interrupt.
* b. When the PHY interrupt occurs, work should be scheduled on the
* worker thread (or perhaps a dedicated application thread).
* c. That worker thread should use the SIOCGMIIPHY, SIOCGMIIREG,
* and SIOCSMIIREG ioctl calls** to communicate with the PHY,
* determine what network event took place (Link Up/Down?), and
* take the appropriate actions.
*
* * This is an OS internal interface and should not be used from
* application space.
* ** This interrupt is really of no use if the Ethernet MAC driver
* does not support these ioctl calls.
*
* Input Parameters:
* intf - Identifies the network interface. For example "eth0". Only
* useful on platforms that support multiple Ethernet interfaces
* and, hence, multiple PHYs and PHY interrupts.
* handler - The client interrupt handler to be invoked when the PHY
* asserts an interrupt. Must reside in OS space, but can
* signal tasks in user space. A value of NULL can be passed
* in order to detach and disable the PHY interrupt.
*
* Returned Value:
* The previous PHY interrupt handler address is returned. This allows you
* to temporarily replace an interrupt handler, then restore the original
* interrupt handler. NULL is returned if there is was not handler in
* place when the call was made.
*
****************************************************************************/
#ifdef CONFIG_SAMA5_PIOE_IRQ
xcpt_t arch_phy_irq(FAR const char *intf, xcpt_t handler)
{
irqstate_t flags;
xcpt_t *phandler;
xcpt_t oldhandler;
pio_pinset_t pinset;
int irq;
DEBUGASSERT(intf);
#ifdef CONFIG_SAMA5_EMAC0
if (strcmp(intf, SAMA5_EMAC0_DEVNAME) == 0)
{
phandler = &g_emac0_handler;
pinset = PIO_INT_ETH0;
irq = IRQ_INT_ETH0;
}
else
#endif
#ifdef CONFIG_SAMA5_EMAC1
if (strcmp(intf, SAMA5_EMAC1_DEVNAME) == 0)
{
phandler = &g_emac1_handler;
pinset = PIO_INT_ETH1;
irq = IRQ_INT_ETH1;
}
else
#endif
{
ndbg("Unsupported interface: %s\n", intf);
return NULL;
}
/* Disable interrupts until we are done. This guarantees that the
* following operations are atomic.
*/
flags = irqsave();
/* Get the old button interrupt handler and save the new one */
oldhandler = *phandler;
*phandler = handler;
/* Configure the interrupt */
sam_pioirq(pinset);
(void)irq_attach(irq, handler);
sam_pioirqenable(irq);
/* Return the old button handler (so that it can be restored) */
irqrestore(flags);
return oldhandler;
}
#endif /* CONFIG_SAMA5_PIOE_IRQ */
#endif /* HAVE_NETWORK */
|