diff options
Diffstat (limited to 'nuttx/configs/stm3220g-eval/dhcpd/defconfig')
| -rw-r--r-- | nuttx/configs/stm3220g-eval/dhcpd/defconfig | 12 |
1 files changed, 1 insertions, 11 deletions
diff --git a/nuttx/configs/stm3220g-eval/dhcpd/defconfig b/nuttx/configs/stm3220g-eval/dhcpd/defconfig index a054711c6..192628a5d 100644 --- a/nuttx/configs/stm3220g-eval/dhcpd/defconfig +++ b/nuttx/configs/stm3220g-eval/dhcpd/defconfig @@ -64,7 +64,7 @@ # CONFIG_ARCH_CALIBRATION - Enables some build in instrumentation that # cause a 100 second delay during boot-up. This 100 second delay # serves no purpose other than it allows you to calibrate -# CONFIG_BOARD_LOOPSPERMSEC. You simply use a stop watch to measure +# CONFIG_BOARD_LOOPSPERMSEC. You simply use a stop watch to measure # the 100 second delay then adjust CONFIG_BOARD_LOOPSPERMSEC until # the delay actually is 100 seconds. # CONFIG_ARCH_DMA - Support DMA initialization @@ -118,15 +118,6 @@ CONFIG_STM32_JTAG_NOJNTRST_ENABLE=n CONFIG_STM32_JTAG_SW_ENABLE=n # -# On-chip CCM SRAM configuration -# -# CONFIG_STM32_CCMEXCLUDE - Exclude CCM SRAM from the HEAP. You would need -# to do this if DMA is enabled to prevent non-DMA-able CCM memory from -# being a part of the stack. -# -CONFIG_STM32_CCMEXCLUDE=y - -# # On-board FSMC SRAM configuration # # CONFIG_STM32_FSMC - Required. See below @@ -148,7 +139,6 @@ CONFIG_HEAP2_END=(0x64000000+(2*1024*1024)) # AHB1: CONFIG_STM32_CRC=n CONFIG_STM32_BKPSRAM=n -CONFIG_STM32_CCMDATARAM=n CONFIG_STM32_DMA1=n CONFIG_STM32_DMA2=n CONFIG_STM32_ETHMAC=y |